Toshiba RBC-TRP100E Manuel D'installation page 28

Branch Kit 1:3
Indoor unit No. before setup change is displayed.
5
Procedure
1. Using temp. setup
specify CODE No. [14].
(CODE No. [14]: Group address)
2. Using timer time
change the setup data from [0001] to
[0002].
(Setup data [Header unit: 0001]
[Follower unit: 0002])
3. Push button.
At this time, the setup finishes when the
display changes from flashing to lighting.
Indoor unit No. before setup change is displayed.
6
Procedure
If there is other indoor unit to be changed,
2
repeat procedure
setup. When the above setup has finished,
push to select the indoor unit No.
before change of setup, specify CODE No.
[12], [13], [14] in order with temp. setup
/ buttons, and then check the
changed contents.
EN
/ buttons,
/ buttons,
5
to to change the
Address change check Before change:
[3-3-1] → After change: [2-2-2]
Pushing button clears the contents of
which setup was changed.
Indoor unit No. before setup change is displayed.
7
Procedure
After check of the changed contents, push
button. (Setup is determined.) When
pushing button, the display disappears
and the status becomes the usual stop
status. (When pushing
operation from the remote controller is not
accepted for approx. 1 minute.)
* If the operation from the remote controller is not
accepted even 1 minute or more passed after
pushing button, it is considered that the
address setup is incorrect.
In this case, the automatic address must be
again set up. Therefore repeat procedure of the
setup change from the Procedure
27
button the
1
.