Toshiba RBC-TRP100E Manuel D'installation page 24

Branch Kit 1:3
NOTE
When using the equipment at the first time, it will take a lot of time that the remote controller
accepts an operation after power was on. However, it is not a trouble.
Automatic address
While automatic addressing, the operation can not be performed on the remote controller.
• For automatic addressing, Max. 10 minutes (generally, approx. 5 minutes) are required.
When power will be turned on after finish of automatic addressing;
• It will require Max. 10 minutes (generally, approx. 3 minutes) that outdoor unit starts
operation after power was on.
 Indoor Unit operation when connected to multiple unit
Simultaneous triple system
A combination with an outdoor unit allows simultaneous ON/OFF operation of three indoor
units for the triple system.
Triple system
Outdoor unit
Indoor unit
Remote
controller
Finish of address setup by
• For wiring procedure and wiring method, follow to the "Electric wiring" in this manual.
• When the power supply has been turned on, the automatic address setup starts and
which indicates that address is being set up flashes on the display part.
During setup of automatic address, the remote controller operation is not accepted.
Required time up to the finish of automatic addressing is approx. 5 minutes.
In case of group control for system of multiple units
One remote controller can control maximum 8 indoor units as a group.
EN
Indoor unit Indoor unit
power-ON
23