hestan KRP Serie Manuel D'installation page 25

LOCATION AND INSTALLATION
MOVING THE UNIT INTO FINAL POSITION
IMPORTANT: The following instructions for installation apply to all models.
For a built-in installation, to close gaps between the appliance and
frames are provided.
1
2
3
(continued)
Push the appliance into the opening.
If the unit is to be installed inside an enclosure or within an
enclosed structure, it is necessary to design a ventilation
shaft at the back of the enclosure to assure proper
ventilation at the back of the unit. A 5 mm (1/4") gap is
suf cient to prevent overheating. Always mount front
panels on the door and drawer before pushing the unit into
its nal position inside the enclosure.
Secure the appliance to the adjacent cabinets using the
previously installed side pro les.
To make this operation easier keep the door and the drawer
open.
Check the leveling of the appliance, adjusting the feet and
wheels to correct it if necessary.
Mount the included covers by rst inserting them laterally
then pushing rmly until a "click" is heard.
1
2
3
©2018 Hestan Commercial Corporation
EN
23