Complete The Installation - Kohler 1103125 Mode D'emploi

Motor Wiring Loom
Connect the Wiring Looms
Connect the motor (2 connections), solenoid, and thermistor
wiring looms to the circuit board.
Verify all connectors and grommets are secured.

Complete the Installation

IMPORTANT! Position the wiring looms so that they are not
pinched when the cover is secured.
Verify all connectors and grommets are secured.
Reinstall the case inserts.
Reinstall the cover using the new screws provided.
Reconnect the inlet and outlet connections.
Connect the power supply and turn on the water supply.
Check for leaks.
Enter the calibration code into the user interface. Path: Settings >
Valve > Service > Activation Code (1012)
Kohler Co.
Solenoid Wiring Loom
Motor Wiring Loom
Second Connection
(not all models)
Thermistor Wiring Loom
Circuit Board
13 1062953-9-D