Kohler 1103125 Mode D'emploi page 10

Calibration Code
Mixer Valve
Valve Inlet
Screw
Inlet Clamp
Adapter
Install the New Mixer Valve and Inlet Clamp
Install the new O-ring onto the solenoid.
Connect the new mixer valve to the solenoid using the new
internal clamps, making sure the lower part of the clamp will
position itself over the screw hole. The screw holes alternate from
one side of the solenoid to the other.
IMPORTANT! Verify that the internal clamps snap into place
securely.
Place the valve unit into the case and secure with the four torx
screws.
Reinstall the inlet adapters using the new inlet clamp.
Read and record the three digit calibration code found on the
valve assembly label.
1062953-9-D
O-Ring
Solenoid
Internal Clamp
10
Internal
Clamp
Screw
Kohler Co.