Kohler 1103125 Mode D'emploi page 9

Calibration Code
Mixer Valve
Valve Inlet
Screw
Inlet Clamp
Adapter
Remove the Old Mixer Valve
Using the T15 torx driver, remove the four internal clamp screws.
Lift out the valve unit from the case.
Using the screwdriver, remove the inlet clamp screws.
Remove the inlet clamp and discard.
Remove the adapters from the valve inlets.
Remove the internal clamp and O-ring connecting the mixer valve
to the solenoid and discard.
Discard the old mixer valve.
Kohler Co.
O-Ring
Solenoid
Internal Clamp
9
Internal
Clamp
Screw
1062953-9-D