Tips On Energy Saving; Service Programmes - Siemens TE506F Série Mode D'emploi

de en

Tips on energy saving

● Switch off the fully automatic espresso
machine when not in use� To do this,
e
press the off /
appliance rinses and switches off�
● If possible, do not interrupt coffee or milk
froth dispensing� Cutting the coffee or milk
froth dispensing process short results in
higher energy consumption and in more
residual water collecting in the drip tray�
● Descale the appliance regularly to avoid
a build-up of limescale� Limescale residue
results in higher energy consumption�

Service Programmes

Tip: Refer also to the quick reference guide
in the storage compartment (5c)�
Depending on usage, the following
messages will appear on the display at
certain intervals:
Descale required!
or
Clean required!
or
Calc'n'Clean required!
The appliance should be cleaned or des-
caled immediately using the corresponding
programme� You also have the option
of combining both processes with the
Calc'n'Clean function (see "Calc'n'Clean")�
If the service programme is not run as
instructed, the appliance may be damaged�
¡
Warning!
Each time you run the service programme,
you should follow the instructions for using
the descaling and cleaning agents� Please
observe the safety instructions on the pack-
aging of the cleaning agent�
Never interrupt the service programme!
Do not drink the liquids!
36
j
button (13)� The
Never use vinegar, vinegar-based products,
citric acid or citric acid-based products!
Never put descaling tablets or other desca-
ling agents in the ground coffee drawer or
the drawer for cleaning tablets (4)!
Specially developed descaling and
cleaning tablets are available from
retailers or customer service (see
„Accessories").
Descaling
Duration: approx� 25 minutes�
Important: If there is a filter in the water
tank (17), it needs to be removed before the
descaling programme is run�
If the message Descale required!
on the display, press the
for 3 seconds and then press the start but-
ton (10)� The descaling programme will start�
To descale the appliance before being
prompted, press the
for at least 3 seconds� Then press the
e
j
off /
button (13) briefly twice. Turn
the upper rotary knob (15) until
appears in the display� To start
descaling
the descaling procedure, press the start
button (10)�
The display will guide you through the
programme�
Empty drip tray
Insert drip tray
● Empty drip tray (8) and replace them�
N.B.: If the water filter (20) is activated, the
display will prompt you to remove the filter
(20) and then press the start button (10)
again. Remove the filter now if you have not
already done so� Press the start button (10)�
appears
e
j
off / button (13)
e
j
off / button (13)
Start