Tips On Energy Saving - Siemens TE65 F Série Mode D'emploi

en

Tips on energy saving

The display 3 will indicate the progress of
the programme:
■ Empty and re-insert the drip tray 17.
■ Open the ground coffee drawer 12.
■ Drop one Siemens cleaning tablet in the
drawer 12 and close it.
■ Touch C.
F
The following request appears:
Remove water filter if inserted ¢start.
■ Remove the filter and then touch
C again.
■ Pour lukewarm water into the empty water
tank 5 up to the "0�5 l" mark and then
dissolve one Siemens descaling tablet
TZ80002N in it.
■ Touch C.
■ Place a container with a capacity of 1 litre
under the beverage outlet 4.
■ Place the end of the suction pipe 4d in
the container.
■ Touch C.
The descaling programme will now run for
about 28 minutes.
F
If there is not enough descaling solu-
tion in the water tank 5, you will see
the prompt Refill descaler ¢start.
■ Add more descaling solution and then
touch C again.
■ Rinse the water tank 5 and refill it with
fresh water up to the "max" mark.
■ If you use a filter, replace it now.
■ Touch C.
The descaling programme will now run
for about one more minute, and then the
cleaning programme will run for about
7 minutes and rinse the appliance.
■ Empty and re-insert the drip tray 17.
46
F
Important: Wipe over the appliance
with a soft damp cloth to ensure that
you immediately remove any traces
of descaling solution. It is possible for
corrosion to form underneath such
deposits. New sponge cloths may
contain salts that can cause rust films
to form on stainless steel, so such
cloths should always be thoroughly
rinsed before use. Clean the suction
pipe 4d of the drinks outlet particu-
larly carefully.
The appliance has finished descaling and is
ready for use again.
F
Important: If any of the service
programmes is ever interrupted, for
instance by a power failure, please
proceed as follows:
■ Rinse the water tank 5 and refill it with
fresh water up to the "max" mark.
■ Touch C.
The appliance will be rinsed for approx.
2 minutes for safety reasons.
■ Empty and re-insert the drip tray 17.
The aborted service programme must
be restarted.
Tips on energy saving
■ When the fully automatic coffee machine
is not in use, use the mains switch J 1 on
the front of the appliance to switch it off.
■ In the menu, set the Automatic shut-down
period to 15 minutes.
■ If possible, do not interrupt the dispensing
of coffee or milk froth. Stopping a process
prematurely results in higher energy
consumption and the drip tray fills up
more quickly.
■ Descale the appliance regularly to avoid a
build-up of limescale. Limescale residues
cause higher energy consumption.