Air Intake - Rizzoli M Série Manuel D'utilisation

2.12 AIR INTAKE
The standard installation of the wood fired cooker
considers that the comburent air is taken from the
room where the cooker is installed through the air
intake of the cooker located in the plinth. In this
case, in the room must be always ensured the re-
cycle of fresh air, in particular if the room is small
and window and door frames are hermetic.
The correct flow of air in the room must be en-
sured also in presence of other combustion based
devices, aspiring hoods, chimneys and vent­holes.
The air intake in the room must have a minimum
surface of 80 cm2. On demand, Rizzoli can give
specific valves which can allow the automatic
opening of the air intake only when it is necessary
for the correct working of the wood fired cooker,
Picture 13 - Installation with air intake in the room of installation and installation with air intake directly con-
nected to the wood fired cooker.
A
Picture 14 - Possible connections of the air intake of the cooker. A = External air intake not connected
B = External air intake on the floor C = External air intake on the wall.
To make the connection easier we suggest to make
the external air intake on the floor in correspon-
dence with the internal part of the plinth, or on the
wall through the rear part of the cooker according
to specifies depending on the model (see picture
15 and table 2).
For ML Range wood fired cookers it is recommen-
in order to warrant a maximum depression of 4 Pa
in the place of installation.
M-MZ-ML Range wood fired cookers can also be
connected so that the comburent air comes di-
rectly from outside. In this way, for the wood fired
cooker it is not necessary another air intake in the
room of installation.
To make this it is necessary to prepare a conduct
connected directly with the external part of the
house and make a direct connection with the air
intake of the cooker. The air intake of the cooker is
located inside the woodbox in correspondence of
the combustion chamber. For the connection, we
suggest to use a flexible pipe.
B
ded to connect the external air intake to the floor
but on demand it is possible to have an optional
item to make the connection to the wall (see pic-
ture 16). Are also possible other solutions for the
connection but they must be decided together
with Rizzoli.
75
C