Rizzoli M Série Manuel D'utilisation page 76

Picture 10 - Tolerance for flue outlet on the top and back. The tolerance depends on the orientation of the connector.
The connection with the chimney must be always
well fixed and sealed, it must not have narrowing
and must not decrease the usable section of the
chimney (see picture 11). If near the cooker there
NO
Picture 11 - Examples of correct and incorrect connection of the chimney
2.11 FLUE OUTLET ON THE SIDE (OPTIONAL)
If the chimney is on the side in correspondence of
a side, it is possible to order the flue outlet on the
side. Also in this case, the connector is extractable.
To install it correctly, it is necessary to remove the
cooking plate. Now, the connector must be com-
pletely inserted inside the wood fired cooker or
Picture 12 - Flue outlet on the side. Fixed connector for the flue outlet on the side.
+/-
10 mm
Y
is inflammable material or high temperatures sen-
sible, the connection must be isolated and the sa-
fety distances must be strictly observed.
NO NO
the chimney, keeping the fixing buttonhole on the
same side of the cooker. Then, you can place the
wood fired cooker, extract correctly the connector
so that it connect the cooker with the chimney.
Finally, bend the buttonhole and block the parts
with the screw­lock (see picture 12).
74
+/-
10 mm
X
YES