Switching Off; Storage Case; Led Light; Maintenance And Care - EUFAB 21077 Manuel De L'opérateur

Bicycle valve adapter (for Dunlop and Sclaverand valves) (15):
For Sclaverand valves: Undo the knurled screw of the valve piston and push down briefly once.
Screw the valve adapter, using the knurled crown, down onto the bicycle valve.
Screw the end of the air hose with the internal thread onto the adapter. Now you can switch on the compressor and fill the bicycle tyre. After you have
finished filling the tyre, detach the air hose and the adapter from the valve.
For Sclaverand valves: Tighten the knurled screw of the valve piston up again.
Adapter for balls (16):
Screw the adapter for balls into the internal thread of the air hose. Insert the adapter into the valve of the ball. Now you can switch on the compressor and
fill the ball.
Universal adapter for leisure items (17):
Screw the universal adapter into the internal thread of the air hose. Insert the universal adapter into the filling connection of your leisure equipment.
Depending on version, it is possible that the universal adapter will need to be held firmly during the filling process. Now you can switch on the compressor
and start the filling process.
Filling process
To start the filling process press the compressor's ON/OFF button (position 5 in the overview).
The compressor will start, during the filling process the pressure will appear on the display.
When the set target pressure has been reached the compressor will switch itself off. Press the ON/OFF button once more.
Only leave the compressor operating uninterrupted for a maximum for 5 minutes.
Allow the compressor to cool down for at least 15 minutes afterwards before using it again.

Switching off:

Press the button for selecting the unit (position 2 in the overview) for 3 seconds, the device will switch off. If no switch is pressed, the device will switch
off automatically.

6.4 STORAGE CASE

In order to be able to the multifunctional compressor when you are out and about, you can transport it in the storage case. The storage case can be
attached to the bicycle frame with the mounting brackets (figures 3 – 6).
Figure 3:Top tube, on top

6.5 LED LIGHT

The LED light (position 7 in the overview) can be turned on by pressing the button (position 4 in the overview). By pressing the button again, you can
turn the LED light off again.

7. MAINTENANCE AND CARE

7.1 MAINTENANCE

Store the compressor in a dry, frost-free place. If the compressor remains unused for long periods of time, charge the battery every 3 months.

7.2 CARE

Switch the multifunctional compressor off before cleaning. Clean the housing with a soft, dry cloth. Do not use any abrasive or solvent-based cleaning
agents. Never allow liquids to ingress into the housing.

8. NOTES REGARDING ENVIRONMENTAL PROTECTION

Do not dispose of electrical devices with the household waste! Electronic and electrical devices must be collected separately and sent
for environmentally friendly recycling. Please contact your community or city administration regarding disposal options for electrical
and electronic scrap.
You are legally obliged to return batteries and battery packs. After use, they may be returned to us, handed in to a communal collec-
tion point, or to a local dealer.

9. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
Figure 4:Top tube, underneath
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
Figure 5:Slanting tube Figure 6:Saddle tube
info@eal-vertrieb.com
www.eal-vertrieb.com
7