Explanation Of Symbols; Operating Instructions; Overview; Charging The Power Pack - EUFAB 21077 Manuel De L'opérateur

5. EXPLANATION OF SYMBOLS

Corresponds to EC directives
Labelled electrical products may not be
disposed of in the household waste
Read the operating instructions

6. OPERATING INSTRUCTIONS

6.1 OVERVIEW

6.2 CHARGING THE POWER PACK

Insert the charging cable (position 21 in the overview) of the plug-in charger (position 19 in the overview) into the charging port of the compressor
(position 11 in the overview). Plug the charger into a mains socket. The charging indicator light (position 12 in the overview) will now light up. During
the charging process the charging indicator light on the plug-in charger (position 20 in the overview) will be red. When the compressor's battery is fully
charged, the indicator light will be green. It takes approximately 4 hours to charge an empty battery.
After charging, first pull the plug-in charger out of the mains socket and separate the compressor from the charging cable. Always maintain this sequence.
Checking the charge status
Press the button for selecting the unit (position 2 in the overview). This will activate the display light. The battery symbol indicates the
charge status (empty, 25%, 50%, 75%, 100%).

6.3 OPERATING THE COMPRESSOR

Setting the target pressure
Press the button for selecting the unit (position 2 in the overview). This will activate the display light. You can set the pressure unit by continuing to press
the button:
PSI -> BAR -> KGF/CM²
With the (-) and (+) buttons (position 3 and 6 in the overview) you can set the target pressure. After you have set the pressure, press the unit selection
button once more, and the display will now show 0.00 again in the chosen unit.
Connecting the air hose
Screw the end of the air hose with the external thread (position 14 in the overview) into the compressor' s connector (position 8 in the overview).
Using the adapter
If you would like to fill a tyre with an auto valve (Schrader valve), you will not require an adapter. Screw the end of the air hose with the internal thread onto
the valve. Now you can switch on the compressor and fill the bicycle tyre.
6
Bild 1: Übersicht
Figure 2: Overview of accessories
Insulated housing (protection class II).
Devices with this symbol may only be operated in-
doors (dry environment)
1. Display
2. Unit selection button
3. (-) Button
4. ON/OFF button for LED light
5. ON/OFF button for compressor
6. (+) Button
7. LED light
8. Connector for the air hose
9. USB port
10. ON/OFF button for USB connection
11. Charging port
12. Charging indicator light
13. USB port indicator light
14. Air hose
15. Adapter for bicycle valves
16. Adapter for balls
17. Universal adapter for leisure items
18. Storage case
19. Plug-in charger
20. Charging indicator light
21. Charging cable