Maintenance Plan; Trouble Shooting - HOLZMANN MASCHINEN HMS 700 Manuel D'utilisation

Check regularly the condition of the machine.
The good condition and perfect adjustment of the guiding rollers is essential for a smooth band
guidance and a clean cut.
Store the machine in a closed, dry location.
Clean your machine regularly after every usage – it prolongs the machines lifespan and is a pre-
requisite for a safe working environment.
Repair jobs shall be performed by respectively trained professionals only!
15.1

Maintenance plan

After each workshift:
 Apply a thin layer of oil on all moveable parts
 Remove grinding cuttings and metal chips from the device
15.2 Cleaning
After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal
surfaces as well as the use of scrubbing agents will damage the machine
surface! Clean the machine surface with a wet cloth soaked in a mild solution
15.3 Disposal
Do not dispose the machine in residual waste. Contact your local authorities for information
regarding the available disposal options. When you buy at your local dealer for a
replacement unit, the latter is obliged to exchange your old.
16

TROUBLE SHOOTING

BEFORE YOU START WORKING FOR THE ELIMINATION OF DEFECTS, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
Machine stops or will not start
Machine slows down during
working
Bad grinding results
Grinding angle is wrong
MANY POTENTIAL SOURCES OF ERROR CAN BE CLEARED BY THE EXPERTLY CONNECTION
TO THE ELECTRICITY GRID.
Should you in necessary repairs not able to properly to perform or you
have not the prescribed training for it always attract a workshop to fix
the problem.
HOLZMANN MASCHINEN GmbH
NOTICE
Possible cause
 ON/OFF-switch damaged
 Saw unplugged
 Overload tripped
 Fuse blown or circuit breaker
tripped
 Cord damaged
 Exerting too much pressure to
the sanding abrasive
 Abrasive too coarse-grained
 Adjusted angle is wrong
www.holzmann-maschinen.at
NOTICE
 Check the switch
 Check all power connections
 Allow motor to cool and reset
by pushing off switch
 Change fuse or reset circuit
breake
 Change cable
 Exert less pressure on the
work piece
 Use less coarsed abrasive
 Readjust the angle
NOTICE
TROUBLE SHOOTING
Solution
28
HMS 700 / HMS 1000