Gear Shifting - Bosch GSR18V-1330C Consignes De Fonctionnement/Sécurité

2610056705 GSB18V-1330C 04-21.qxp_GSB18V-1330C GSR18V-1330C 5/3/21 7:00 AM Page 14
Variable Speed Controlled
Trigger Switch
Your tool is equipped with a variable speed
trigger switch. The tool can be turned
"ON" or "OFF" by squeezing or releasing
the trigger. The speed can be adjusted
from the minimum to maximum nameplate
RPM by the pressure you apply to the
trigger. Apply more pressure to increase
the speed and release pressure to
decrease speed (Fig. 1).
Forward/Reversing Lever &
Trigger Lock
position to help prevent accidental starts
and accidental discharge.
Your tool is equipped with a forward/
reversing lever and trigger lock (16)
located above the trigger (Fig. 8). This lever
was designed for changing direction of
rotation of the bit, and for locking the
trigger in an "OFF" position.
For forward rotation, (with chuck pointed
away from you) move the lever to the far
left (Fig. 8).
For reverse rotation, move the lever to the
far right (Fig. 8).
To activate trigger lock, move lever to the
center off position.

Gear Shifting

Your tool is equipped with two separate
gear ranges, low gear 1 and high gear 2.
Low gear provides high-torque and slower
drilling speeds for heavy duty work or for
driving screws. High gear provides faster
speeds for drilling lighter work. To change
speeds slide switch (7), to the high 2 or
low position 1 (Fig. 9).
ATTENTION: If your tool appears to be
running, but the chuck will not turn, check
to make sure the gear shifter is pushed
fully into desired setting.
Operating Instructions
After tool use, lock
trigger in "OFF"
Do not change direction of
rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to the
tool.
FIG. 8
(16)
14
(16)
FIG.9
(7)