Connect Vent System - KitchenAid LI3ZHA Instructions D'installation Et Guide D'utilisation Et D'entretien

2. Install the transition piece using 3 - 4.2 x 8 mm mounting
screws to the range hood canopy.
3. Install the lower support bracket removed in Step 1 using the
10 - 4.2 x 8 mm mounting screws to the range hood canopy.
B
A
B
A. Lower support bracket
B. 4.2 x 8 mm mounting screws
C. Transition piece
4. Position the 4 vertical supports (A) with the notches at the
bottom and attach to the range hood using 16 - 4.2 x 8 mm
screws.
5. Attach the horizontal support (B) using 8 - 4.2 x 8 mm screws.
A
C
A. Vertical supports
B. Horizontal support
C. Notched end
8
C
B
A
C
6. Attach a second set of vertical supports (A) and set the
vertical height (B). See "Installation Clearances" in the
"Location Requirements" section to help determine the
desired dimension for vertical height "B."
A
A. Vertical supports
B. Vertical height
7. Attach the range hood assembly to the upper horizontal
support attached to the ceiling using 16 - 4.2 x 8 mm screws
and tighten.
A
A. Mounting screws
8. Install the 4 supports using 8 - 4.2 x 8 mm screws.
9. Attach the vertical duct cover supports using 4 - 4.2 x 8 mm
screws.
A. Support
B. 4.2 x 8 mm screws
C. Vertical duct cover support

Connect Vent System

1. Install vent system.
2. Push duct over the exhaust outlet. Seal all connections with
vent clamps.
A
B
A
B
C