KitchenAid LI3ZHA Instructions D'installation Et Guide D'utilisation Et D'entretien page 10

Dual Blower Motor Assembly
A. Wiring connection
2. Slide the left mounting plate flange under the motor mounting
bracket.
A B
A. Motor mounting bracket
B. Mounting plate left flange
3. Run the power supply wires and connector from the range
hood through the hole in the right end of the motor mounting
plate.
A. Motor mounting plate hole
B. Power supply wires and connector
4. Push the right end of the motor mounting plate up and snap it
into the spring tab.
10
NOTE: The spring tab should be outside the slot in the
mounting plate.
A
5. Align mounting holes and install 6 x 16 mm screws and
6.4 mm lock washers.
A
6. Attach power supply connector from the range hood to the
connector on the blower motor assembly wiring box.
B
7. Go to the "Make Electric Power Supply Connection to Range
Hood" section.
A. Motor mounting plate
B. Spring clip
A
B
A. Screw with lock washer
B. Mounting hole
A
B
A. Wiring box connector
B. Power supply connector from range hood
A
B