Install Range Hood; Connect Vent System; Make Electrical Connection - KitchenAid 30" Instructions D'installation Et Guide D'utilisation Et D'entretien

Install Range Hood

1. Using 2 or more people, hang range hood on 2 mounting
screws through the mounting slots on back of hood.
A
B
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
2. Remove the grease filter. See "Range Hood Care" section.
3. Level the range hood and tighten upper mounting screws.
4. Install 2 - 5 x 45 mm lower mounting screws and tighten.

Connect Vent System

1. Install transition on top of hood (if removed for shipping) with
2 - 3.5 x 9.5 mm sheet metal screws.
A
B
A. Vent transition
B. 3.5 x 9.5 mm screw
For vented installations only:
1. Fit vent system over transition piece.
2. Seal connection with clamps.
3. Check that back draft dampers work properly.
8
For non-vented (recirculating) installation only:
1. Assemble the air deflector with the duct cover bracket using
4 - 4 x 8 mm screws.
2. Measure from the bottom of the air deflector to the bottom of
the hood outlet.
C
A. Air deflector
B. Vent clamp
C. X = length to cut vent duct
3. Cut the duct to the measured size (X).
4. Remove the air deflector.
5. Slide the duct onto the bottom of the air deflector.
6. Place the assembled air deflector and duct over the exhaust
outlet from the hood.
7. Reassemble the air deflector to the duct cover bracket with
the 4 assembly screws.
8. Seal connections with vent clamps.

Make Electrical Connection

Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
2. Remove terminal box cover.
B
C
A. Assembly screws
B. Air deflector
C. Duct cover bracket
A
B
X
D
E
D. Vent duct
E. Exhaust outlet
WARNING
Electrical Shock Hazard
A
C