Assembly And Operation; Accessories - Worx WX845 Notice Originale

ensuring it is sharp and in good condition.
If any anti noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
noise accessories.

ACCESSORIES

Battery pack (WA3553)
Charger (WA3880)
Wood cutting blade
(WA8201)
Blade wrench
Dust bag
Folding work supports
Work-holding lever
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The mitre saw is intended as a stationary machine for
making straight lengthways and crossways cuts in
wood. Horizontal mitre angles of 0~45
as vertical bevel angles of 0° to +45° are possible.
20V Sliding Compound Miter Saw
WX845 WX845.9
1 /
1 /
1 1
1 1
1 1
2 2
1 1
o L&R as well

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
ASSEMBLY
Bench mounting
WARNING: Always make
sure your miter saw is securely
mounted to a workbench or an
approved work-stand.
Installing and removing the saw
blade
NOTE:
1. Loosen, but do not remove the
bolt cover screw;
2. Do not remove any other screws;
3. Press and hold the spindle lock
button, keep rotating the saw blade
until it locks (a "Click" is heard)
before changing the blade.
WARNING: Always remove
the battery pack before
changing the blade!
WARNING: The blade bolt
cover must be positioned
correctly and the bolt cover screw
must be screwed securely before
cutting.
CAUTION: Never depress the
spindle lock button while the blade
is under power or coasting.
Installing the work holding lever
With the lever on the left, lift the
assembly over the fence into the
locating pivots.
Swing the retaining knobs over the
shaft to lock in place.
NOTE:
The lever should move smoothly but
not fall.
If too loose, tighten the retaining knob
screws.
Installing the work supports
The folding work supports make
cutting long work much easier.
To install, squeeze the ends together,
insert into the slots in the table and
allow to spring outward.
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
See Fig. B
See Fig.
C1-C3
13
See Fig. D
See Fig. E
EN