Accessories; Intended Use; Assembly And Operation - Worx AXIS WX550 Notice Originale

noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ
from the declared value depending on the ways
in which the tool is used especially what kind of
workpiece is processed dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing
the job. This may significantly reduce the exposure
level over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.

ACCESSORIES

WX550 WX550.1 WX550.4 WX550.5 WX550.9
1 1
Charger
(WA3880) (WA3880)
Battery pack
1 2
(WA3551.1)
Wood
cutting jig 1 1
saw blade
20V Li-Ion multi-purpose saw
1 1
/
(WA3880) (WA3880)
1 1 /
1 2 1
Metal
cutting jig 1 1
saw blade
Aluminum
cutting jig 1 1
saw blade
Wood
cutting rep 1 1
saw blade
bottom
1 1
plate
Rough
wood and
firewood
/ /
cutting rep
saw blade
(WA8008)
We recommend that you purchase your accessories
listed in the above list from the same store that sold
you the tool. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.

INTENDED USE

The machine is 2 saws in 1 tool with rep saw and
jig saw function, intended for sawing wood, plastic,
metal and building materials while resting firmly on
the workpiece. It is suitable for straight and curved
cuts.

ASSEMBLY AND OPERATION

ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
1 2 1
1 2 1
1 1 1
1 1 1
1 / /
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
EN
11