Final Assembly - Heath Zenith 5942 Mode D'emploi

WARNING: Turn power off at circuit breaker or fuse.
Place tape over circuit breaker switch and verify power is
off at the fixture.
This fixture comes with a 1-2- asy Connect™ mounting plate. It is
pre-assembled on the fixture for shipping.
1. Unscrew the center mounting bolt connecting the fixture canopy
to the 1-2- asy Connect™ and remove the 1-2- asy Connect™
(see Figure 1). The mounting bolt is designed to stay in the light
fixture. Note: Be sure rubber gasket is on the 1-2- asy Connect™.
2. Install the mounting bracket with the stamped word "FRONT"
facing away from the junction box (see Figure 2). Use the mount-
ing bracket screws that best fit the junction box.
3. Route the junction box wires through a hole in the 1-2- asy
Connect™ (see Figure 3).
4. Place the 1-2- asy Connect™ against the junction box (see
Figure 3).
• Wall Mounted – The "UP" arrow must point upward
• Eave Mounted – The "UP" arrow must point toward the build-
ing
5. Insert the small mounting bolt through the 1-2- asy Connect™
hole located below the threaded hole. Thread the bolt into the
center hole of the mounting bracket (see Figure 3). Tighten bolt
securely.
Insert the junction box wires into the side of the terminal block and
around the ground screw (see Figure 4). Tighten terminal block screws
and ground screw to secure wires.
• White to "N (White)"
• Black to "L (Black)"
• Bare or green ground wire to GND (ground) screw.

FINAL ASSEMBLY

1. Double check that all wiring connections are securely connected.
2. Verify the rubber gasket is properly seated around the edge of
the 1-2- asy Connect™ (see Figure 5).
3. Align the bottom edge of the light fixture with the bottom edge of
the 1-2- asy Connect™. Tilt the light fixture toward the 1-2- asy
Connect™ making sure the light fixture is centered on the 1-2- asy
Connect™.
IMPORTANT: The two pins on the rear of the light fixture must
insert into the terminal block for the light to work.
206619-03
INSTALLATION
WIRING
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
Figure 1
T
O N
F R
T
O N
F R
Figure 2
UP/Haut/Arriba
Figure 3
N (White)
Figure 4
T
N
O
R
F
GND
3