Heath Zenith DualBrite 5512 Mode D'emploi

D B Twin Halogen
®
ual rite
Motion Sensing Light
Model 5512
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• D B Timer.
®
ual rite
• Photocell keeps the lighting off during daylight
hours.
• LED indicates motion was sensed (day or night).
This package includes:
Plastic Hanger
Rubber Plug
Cover Plate
Light Control
Mounting Bolt
Mounting Strap
2 Halogen Bulbs
(Installed)
Requirements
• The light control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a
qualified electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
© 2012 HeathCo LLC
6 Mounting
Screws (3 sizes)
3 Wire
Connectors
Sensor
Gasket
Light Shield
OPERATION
Mode: On-Time
Test
5 Seconds
Auto
1, 5, or 20 Minutes
Manual
To Dawn*
Accent 3, 6 Hours to Dawn
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
Put ON-TIME switch
on the sensor bottom
to TEST and the D -
ual
B switch OFF.
®
rite
Put the ON-TIME switch in the
1, 5, or 20 minute position.
MANUAL MODE
Manual mode only works at night
because daylight returns the
sensor to AUTO.
Flip the light switch off for one
second then back on to toggle
between AUTO and MANUAL
MODE.
Manual mode works only with
the ON-TIME switch in the 1, 5,
or 20 position.
Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
Works: Day Night
x
/ minutes for
1
2
TEST
ON-TIME D B
ual rite
TEST 1 5 20 Off 3 6 Dusk to
Dawn
AUTO
ON-TIME
TEST 1 5 20
1 Second
OFF then...
... back on.
Move ON-TIME Switch to
1, 5, or 20 minutes
Flip light switch off
for one second then
back on*
204057-01A
x
x
x
x
®