Final Setup; Adjustment Of Coverage Area - Heath Zenith Secure Home DualBrite SH-4300-BK Manuel D'installation

Final Setup

1. Adjust the sensitivity (SENSITIVITY) to increase or
decrease the range as needed. Too much sensitivity may
cause false triggering due to heat sources in the cover-
age area (see Testing and Adjustments or Troubleshooting
section).
2. Set the amount of ON-TIME you want the light to
stay on after motion is detected (1, 5, or 10 minutes).
3. Set the DualBrite® switch to off, 3 hours, 6 hours,
or dusk-to-dawn.
Operating Modes
Mode: On-Time
Test 5 Seconds
Auto
1, 5, or 10 Minutes
Accent 3, 6 Hour, To Dawn
Manual
To Dawn*
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
• Motion Sensor (AUTO) – This light fixture is designed
to automatically turn on when the sensor detects a tem-
perature difference moving across the front of the motion
sensor. The light will turn off automatically after a set
amount of time. The ON-TIME control should be set
to 1, 5, or 10 minute setting and the wall switch should
be left in the ON position at all times.
• Optional DualBrite® Control – This optional feature
allows the light fixture to turn on at a lower light level
after dusk (sunset) for the amount of time selected. When
motion is detected, the lights will turn on full bright. This
feature can be turned OFF and the motion sensor will
continue to work in AUTO mode.
• Manual Mode – This light can be activated to stay on full
bright after dusk (sunset) for only one night at a time. It
automatically resets to motion sensing at dawn (sunrise).
Manual mode must be re-activated each night. Note: If
power to the light fixture is off for more than 5 seconds,
allow the electronic circuitry in the sensor to calibrate
(90 seconds) prior to switching to manual mode.
1. To turn on MANUAL mode, switch the light off at
the wall switch for 1 to 2 seconds and then back on.
2. To return to AUTO mode, switch the light off at the
wall switch for 1 to 2 seconds and then back on.
200478-03
Works: Day Night
x x
x
x
x
/ minutes for
1
2
7
Note: The sensor will also reset to AUTO mode at
sunrise.
Turn Switch OFF for
1 to 2 seconds

ADJUSTMENT OF COVERAGE AREA

The sensor on this light fixture detects "motion" by the move-
ment of heat (body heat) across the coverage area. However,
following are examples of objects that also produce heat and
can cause the sensor to false trigger:
• Pools of Water • Air Conditioners
• Dryer Vents • Fenced-In Animals
• Heating Vents • Automobile Traffic
If you suspect that a heat source of this type is falsely trig-
gering the sensor and reducing the sensitivity does not solve
the problem, then a lens shield (included) can be installed.
The plastic lens shield is divided into 6 sections. Each sec-
tion will reduce the coverage angle by 30 degrees. Also, the
tip of each section may be removed to change the effective
range of the sensor.
1. Break off the amount of lens shield needed to block
the desired area of coverage.
2. Cut desired amount of foam tape needed to adhere the
lens shield to the sensor lens.
Lens
Shield
Effective Coverage
Area (Top View)
Lens
Shield
Portion
Removed
Turn Switch
Back ON
Area
Blocked
Area
Blocked