Wiring The Light Fixture; Recommended Grounding Method - Heath Zenith Secure Home DualBrite SH-4300-BK Manuel D'installation

WIRING THE LIGHT FIXTURE

WARNING: Turn power off at circuit breaker
or fuse.
Note: All wiring must be run in accordance with the Na-
tional Electrical Code through conduit or another accept-
able means. Contact a qualified electrician if there is any
question as to the suitability of the system.
CAUTION: DO NOT connect the RED wire
unless you want to control other lights from the
motion sensor (see Optional Wiring).
Black
Green
or Bare
Copper
White
One Motion Light
White
Light
Fixture
Black
Green
or Bare
Copper
Two Motion Lights
Connect the fixture wires to the wires in the junction box.
Twist the wires together and secure with wire connectors.

Recommended Grounding Method

Use a green ground "pigtail" (not provided) and twist
one end together with the bare fixture wire and the box
ground wire. Secure with a wire connector. Secure the
other end of the "pigtail" with the GND screw on the
mounting plate.
Light
Fixture
If you have a metal junction box, you may not need the green
"pigtail". If you are unsure about the grounding method,
consult your local building code.
Light
Fixture
4
White to white
Black to black
200478-03