Heath Zenith DUAL BRITE SL-5318 Mode D'emploi

Dual Brite
Sensor Light
Control for
Canadian Tire
Model SL-5318
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Dual Brite™ Timer.
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
This package includes:
Lamp Holders Rubber Plug
Cover Sensor
Plate
Light Control
Mounting Strap
Mounting Bolt
Plastic Hanger
Requirements
• The Light Control requires 120-volts AC.
• If you want to use the Manual Mode, the control must
be wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
© 2003 DESA Specialty Products™
All manuals and user guides at all-guides.com
™
Motion
2 Shells
Gasket
6 Screws
(3 sizes included)
2 Wire Connectors
OPERATION
Mode: On-Time:
Test 5 Sec
Auto 1, 5, 20 min.
Manual Until Dawn*
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
TEST
Put ON-TIME switch on
the sensor bottom to
TEST and the Dual
Brite™ switch OFF.
AUTO
Put the ON-TIME switch in the 1, 5, or
20 minute position.
MANUAL MODE
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the ON-
TIME switch in the 1, 5, or 10 position.
Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the
calibration time the control will be in the AUTO mode.
Dual Brite™ TIMER
Light comes on half bright for selected time after dusk
(Off, 3 hr., 6 hr., until dawn). If motion is sensed, the light
turns on full bright for the ON-TIME (1,5, or 20 minutes)
then returns to dim mode.
Works: Day Night
x x
x
x
1
/ minutes for
2
ON-TIME DUAL BRITE™
TEST 1 5 20 Off 3 6 Dusk to
Dawn
ON-TIME
TEST 1 5 20
1 Second OFF
then...
... back on.
Move ON-TIME Switch to
1, 5, or 20 minutes
Flip light switch off
for one second then
back on*
598-1001-02