Télécharger Imprimer la page

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Professional
Motion Sensor Quartz
Security Light
Model SL-5311
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• D
B
Timer.
®
ual
rite
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
This package includes:
Cover
Plate
Sensor
Light Control
Requirements
• The light control requires 120-volts AC.
• This fixture is designed for wall mounting only.
• If you want to use Manual Override, the control must
be wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
• The backplate has knockouts so the sensor can be
mounted on most junction boxes.
• In some applications a universal adaptor plate may
be needed. Adaptors are available at Home Centers
and Electrical Supply Stores.
© 2007 HeathCo LLC
All manuals and user guides at all-guides.com
Cover Plate
Gasket
6 Screws
Halogen
(3 sizes)
Bulb
3 Wire Nuts
S-hook
OPERATION
Mode:
On-Time:
Test
5 Sec
Normal
1, 5, 20 min.
Manual
Until Dawn*
Accent
3, 6 Hr. to Dawn
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
TEST
Put ON-TIME switch
ON-TIME
on the sensor bottom
to TEST and the D
-
ual
B
switch OFF.
®
rite
AUTO
Put the ON-TIME switch in the 1, 5, or
20 minute position.
MANUAL MODE
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 20
position.
Mode Switching Summary
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
D
B
ual
rite
Light comes on half bright for selected time after dusk
(Off, 3 hr., 6 hr., dusk to dawn). If motion is sensed, the
light turns on full bright for the ON-TIME (1, 5, or 20
minutes) then returns to dim mode.
Works:
Day
Night
x
/
minutes for
1
2
D
B
®
ual
rite
Off 3 6 Dusk to
TEST 1 5 20
Dawn
ON-TIME
TEST 1 5 20
1 Second OFF
then...
... back on.
Move ON-TIME Switch
to 1, 5, or 20 minutes
Flip light switch
off for one second
then back on*
TIMER
®
595-5497-12
x
x
x
x

Publicité

loading

Sommaire des Matières pour Heath Zenith SL-5311

  • Page 9 3, 6 h jusqu’à l’aurore professionnelle tuation * Revient au mode automatique au lever du soleil. Note: Après mise en circuit, attendre enfiron Modèle SL-5311 minute pour que l’étalonnage du circuit soit complété. Caractéristiques ESSAI • Allume l’éclairage lorsqu’un mouvement est détecté.
  • Page 10 All manuals and user guides at all-guides.com INSTALLATION Montage De La Commande D’Éclairage ❒ Aligner la plaque de garde de la commande d’éclai- Attention, risque d’incendie - Cet appareil est conçu rage et le joint à la plaque d’adaptation (s’il y a lieu) pour montage mural seulement.
  • Page 11 All manuals and user guides at all-guides.com ESSAIS ET RÉGLAGES ❒ Desserrer la vis de blo- Vis de cage de la rotule et faire blocage ❒ Mettre en circuit le disjoncteur et l’interrupteur pivoter le détecteur pour d’éclairage. pointer. Rotule NOTE: Le capteur doit se réchauffer minute avant ❒...
  • Page 12 All manuals and user guides at all-guides.com GUIDE DE DÉPANNAGE SYMPTÔME CAUSE POSSIBLE SYMPTÔME CAUSE POSSIBLE Les lampes Les lampes 1. Un projecteur se trouve trop près du dé- 1. L’interrupteur d’éclairage est en position hors ne s’allument restent allumées circuit.