Bulb Replacement; Care And Maintenance - Heath Zenith Secure Home DualBrite SH-4300-BK Manuel D'installation

3. Remove paper backing from one side of cut foam tape
and adhere foam tape to inside of lens shield.
4. Remove paper backing from other side of cut foam tape
and adhere lens shield to sensor lens.
5. Retest to confirm that the sensor is no longer false
triggering.
Note: To help determine amount of lens shield required,
apply small sections one at a time. Additional sections can
be applied if necessary.
®
I T E
B R
A L
D U
S K
W N
D U
D A
T O
6
3
F
O F
N
M I
1 0
5
M E
1
- T I
S T
T E O N
Lens Shield
1. While holding the light fixture cover with one hand,
remove the two decorative nuts holding the cover onto
the base.
2. Replace bulb(s) (tungsten incandescent, candelabra
base, type "B", 25 watt maximum).
3. Replace light fixture cover onto fixture base.
4. Secure with decorative nuts.
Sensor Lens

CARE AND MAINTENANCE

• To prolong the original appearance, clean with clear water
and a soft damp cloth only.
• Do not use paints, solvents, or other chemicals on this
light fixture. They could cause a premature deterioration
of the finish. This is not a defect in the finish and will not
be covered by the warranty.
• Do not spray with hose or power washer.
8

BULB REPLACEMENT

Light Fixture Base
IT E ®
B R
A L
D U
S K W N
D U
D A
6 TO
3
F
O F
M IN
10
5 E
-T IM 1
S T
T E O N
Decorative Nut
Light Fixture Cover
Remove Light Fixture Cover
200478-03