Mounting The Light Fixture; Testing And Adjustments; Initial Setup - Heath Zenith Secure Home DualBrite SH-4300-BK Manuel D'installation

MOUNTING THE LIGHT FIXTURE

1. Make sure wire connectors and wires are inside the
junction box.
2. Slide the fixture base onto the mounting screws and
tighten the decorative nuts snugly against the base.
3. Install four candelabra base light bulbs (25 Watts
maximum each, tungsten incandescent).
4. Refer to Testing and Adjustments section before installing
cover.
25 Watt Candelabra
Base Bulb
IT E ®
B R
A L
D U
S K W N
D U
D A
T O
6
3
F
O F
M IN
1 0
5
1 E
S T -T IM
T E O N
Decorative
Nut

TESTING AND ADJUSTMENTS

Initial Setup

The TEST mode overrides the photocell (daylight shutoff
feature) and allows the light fixture to be tested day or night
when the ON-TIME switch is in the TEST position. The
light will stay on for 5 seconds after all motion has stopped.
Sensor
Lens
Junction Box
Mounting Screw
1. Turn the DualBrite control to OFF.
2. Set the ON-TIME control to TEST.
3. Set SENSITIVITY control to MIN position.
4. Turn on the circuit breaker or fuse and the light switch.
5. Allow the sensor to completely warm up (90 seconds)
before beginning the setup process.
6. Perform a walk test. Walk in an arc across the front of
the sensor.
* Without lens shield installed.
6
IT E ®
B R
A L
D U
S K
W N
D U
D A OFF 3
T O
6
3
F
O F
M IN
1 0
5
1 E
-T IM
S T
T E O N
+
IT Y
IT IV
N S –
S E
+
Sensor Controls
8 ft . (2 .4 m)
30 Feet (9 .1 m) in
all Directions
Maximum Range
DualBrite ®
DUSK
6 TO DAWN
HR HR
TEST 1 5 10 MIN
ON-TIME
SENSITIVITY
–
360°
Maximum Coverage
Angle* (Top View)
200478-03