Mounting The Light Fixture; Testing And Adjustments - Heath Zenith DualBrite 4034-07 Instructions D'installation Et Mode D'emploi

MOUNTING THE LIGHT FIXTURE

1. Make sure wire connectors and wires are inside the
junction box.
2. Slide the fixture assembly onto the mounting screws.
Tighten decorative nuts removed in step 1 of Light
Fixture Installation section securely against fixture base.
Decorative Nut
3. Install one medium base light bulb (100 Watt maximum,
tungsten incandescent).
4. Caulk around fixture base with silicone weather sealant.
Caulking Around Fixture Base
210069-01
The TEST mode overrides the photocell (daylight shutoff
feature) and allows the light fixture to be tested day or night
when the DUALBRITE switch is in the TEST position. The
light will stay on for 5 seconds after all motion has stopped.
Mounting Screw
1. Slide the CHANNEL switch to OFF.
2. Slide the DUALBRITE switch to TEST.
3. Set sensitivity control (SENS) to MIN position.
4. Turn on the circuit breaker or fuse and the light switch.
Junction
5. Allow the sensor to completely warm up (90 seconds)
Box
6. Perform a walk test. Walk through the coverage area
7. Stop, wait for the light to turn off (5 seconds), and then
8. Adjust the sensitivity (SENS) to increase or decrease
6 ft .
(1 .8 m)
5

TESTING AND ADJUSTMENTS

SENS
CHANNEL
–
OFF A B C
Sensor Controls
before beginning the setup process.
noting where you are when the lights turn on.
begin walking again. Continue this process until the
detection zone has been established.
the range as needed. Too much sensitivity may cause
false triggering due to heat sources in the coverage area
(see Testing and Adjustments or Troubleshooting section).
30 ft . (9 .1 m)
Maximum Range
DUALBRITE
+
OFF TEST 4H D2D
150°
Maximum Coverage Angle
(Top View)