Operating Modes; Care And Maintenance - Heath Zenith DualBrite 4034-07 Instructions D'installation Et Mode D'emploi

OPERATING MODES

Mode: On-Time
Test
5 Seconds
Auto
5 Minutes
Off, 4 Hours, Dusk-to-
Accent
Dawn
Manual
6 Hours or Dawn*
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
• Motion Sensor (AUTO) – This light fixture is designed
to automatically turn on when the sensor detects a tem-
perature difference moving across the front of the motion
sensor. The amount of time the lights stay on at full bright
after ALL motion has stopped in front of ALL linked lights
is preset to 5 minutes.
• Optional DualBrite® Control – DualBrite mode is
a selectable feature that turns the light on at dusk in a
reduced light level. The light will stay on at the reduced
light level for the amount of time selected [Off, 4 hr.,
dusk-to-dawn (D2D)]. When motion is detected, the light
will increase to full bright. The light will stay on at the full
bright level for 5 minutes after ALL motion has stopped
in front of ALL linked lights. The light will then return
to the reduced light level. Once the DualBrite timer runs
out, the light will turn ON only when motion is detected
by any of the linked lights. Selecting OFF disables the
DualBrite feature, however the motion sensing and Link
features will continue to work.
For linked lights, the first light to sense darkness will
turn on all other linked lights on the same channel if the
DualBrite timer has been turned ON on each linked light.
The lights will turn OFF independently of each other and
may not turn OFF at exactly the same time.
210069-01
Works: Day Night
x x
x
x
x
/ minutes for
1
2
• Manual Mode – Manual mode overrides the motion sen-
sor and "DUALBRITE" control so the light will operate
full bright. This feature only works at night and only for
one night at a time. The motion sensor will reset to motion
sensing mode after 6 hours or sunrise, whichever comes
first. Manual mode can be toggled on and off using a wall
switch. Note: If the power to the light fixture is off for
more than 5 seconds, allow the motion sensor to warm
up prior to switching to manual mode.
1. Ensure the power to the light is ON and the sensor
has warmed up (90 seconds).
2. To turn manual mode on after dark, switch the power
OFF–ON–OFF–ON at the wall switch within 5 sec-
onds.
3. To turn manual mode off, switch the power OFF–ON–
OFF–ON at the wall switch within 5 seconds.
OFF ON
Less than 5 seconds
IMPORTANT: If manual mode does not turn ON or OFF,
use a slower pace turning the power ON and OFF at the
wall switch while staying within 5 seconds.

CARE AND MAINTENANCE

• To prolong the original appearance, clean with clear water
and a soft damp cloth only.
• Do not use paints, solvents, or other chemicals on this
light fixture. They could cause a premature deterioration
of the finish. This is not a defect in the finish and will not
be covered by the warranty.
• Do not spray with hose or power washer.
7
OFF ON