Complete The Installation - Heath Zenith DualBrite SL-4290 Serie Mode D'emploi

COMPlete tHe
iNStallatiON
❒ Stuff the wires into the junction box. Make
sure none of the wires get pinched.
Slide the fixture onto the mounting
screws and tighten nuts.
❒ Install light bulb (100 Watt maximum).
❒ Install the lower glass assembly (if
applicable). Secure with decorative
screws.
❒ After completing the tests, caulk between
fixture canopy and mounting surface
with silicone weather sealant.
teStiNG
❒ turn on the circuit breaker and light
switch.
Note: Sensor has a 1
riod before it will detect motion. When
first turned on, wait 1
Note: Meets the ENERGY STAR
®
when D B function is off.
UAL RITE
❒ Switch the on-time to TEST position and
®
D B switch to the OFF position.
UAL RITE
teSt 1 5 10 MIN
ON-TIME
598-1277-01
Junction
Box
Mounting
Surface
Canopy
1 / minute warm up pe-
2
1
/ minutes.
2
® guidelines
OFF 3 6 DuSK tO
HOur DaWN
avoid aiming the control at:
• Objects that change temperature rapidly,
such as heating vents and air condition-
ers. These heat sources could cause false
triggering.
• Areas where pets or traffic may trigger
the control.
• Nearby large, light-colored objects
reflecting light may trigger the shut-off
feature. Do not point other lights at the
sensor.
6 ft.
(1.8 m)
Maximum Range
The detector is less sensitive to motion di-
rectly towards it and more sensitive to across
motion.
Motion
Least Sensitive
5
30 ft.
(9.1 m)
Maximum
Coverage Angle
Motion
Sensor
Most Sensitive
150°