Important Considerations; Manual Mode - Heath Zenith 5942 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

AVOID AIMING THE SENSOR AT:

• Below are examples of objects that might produce heat and may cause the motion sensor to trigger:

• Pools of Water

• Animals

If you suspect that a heat source of this type is triggering the motion sensor, reduce the sensitivity.

• Areas where pets or traffic may trigger the motion sensor.

• Nearby large, light-colored objects reflecting light may trigger the shut-off feature. Do not point other lights at the

motion sensor.

SEASONAL CHANGES:

The motion sensor works by sensing temperature changes across its field of view. The closer the surrounding tempera-

ture is to a person's body heat, the less sensitive the sensor will appear. The greater the temperature difference, the more

sensitive the sensor will appear. The sensitivity (SENS) switch might need to be readjusted as the outside temperature

changes for the different seasons. This is a normal part of the light sensor's operation.

DualBrite mode is a selectable feature that turns the light on at a reduced (accent) level at dusk. When motion is de-

tected, the light will increase to full bright for the amount of the ON-TIME setting (1, 5, or 20 minutes) then returns to

DualBrite mode. The light will stay on at the reduced light level for the amount of time selected (Off, 3 hr., 6 hr., dusk-

to-dawn) and then turn off completely. Once the DualBrite timer runs out, the light will turn ON only when motion

is detected. Selecting OFF disables the DualBrite feature, however the motion sensing features will continue to work.

DualZone increases the motion sensing detection zone by increasing the sensor coverage area. This feature adds addi-

tional protection under the light fixture and against the wall of the home or building for "no where to hide" protection.

Manual mode overrides the motion sensor and "ON-TIME" control so the

light will operate full bright. This feature only works at night and only for

one night at a time. The motion sensor will reset to motion sensing mode at

6 hours or sunrise, whichever comes first. Manual mode can be toggled on

and off using a wall switch.

• To turn manual mode on, switch the light off at the wall switch for 1 to 3

seconds and then back on.

• To turn manual mode off, switch the light off at the wall switch for 1 to 3

seconds and then back on.

206619-03