Preparing For The Installation Of The Tv - Sony SU-WL450 Informations D'installation

Preparing for the installation
of the TV
Make sure to attach the Table-Top stand
before installing the TV to the wall by referring
to the Setup Guide.
1
Remove the screws from the
rear of the TV.
2
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring to
"Supplied with SU-WL450" in
"Checking the parts" on page
5.
Note
 Firmly secure the Attachment parts using screws.
 When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
 Be sure to store the used or unused parts in a safe
place for future use. Retain this manual for future
reference.
Standard mounting (2-a)
Belt 
Screw (+PSW 6 x 50) 
Pulley 
Screw
(+PSW 6 x 20) 
Spacer
(60 mm) 
− 9 (GB) −
Slim mounting (2-b)
Belt 
Screw (+PSW 6 x 20) 
3
Connect the necessary cable(s)
to the TV.
Make sure to connect the cables before
installing the TV on the wall. You will be
unable to connect the cables when the TV
is installed.
Refer to the Reference Guide supplied with
your TV.
Note
 Subcontract the cable routing in the wall to a licensed
contractor.
 Bundle the connecting cables to prevent stepping on
them before wall mounting.
4
Detach the Table-Top Stand
from the TV.
Note
 Be careful when lifting the TV as the Table-Top Stand
is detached, the Table-Top Stand may topple over
and cause personal injury.
 Take care when removing the Table-Top Stand from
the TV to prevent it from falling over and damaging
the surface that the TV is sitting on.
Pulley 
Spacer (20 mm)

GB