Installing The Slide Assemblies For - Dell PowerEdge 1750 Guide D'installation

5X860eb0.fm Page 24 Monday, October 21, 2002 11:49 AM
8
F i g u r e 1 - 1 8 .
C o n f i g u r a t i o n
two-post open-frame rack
12-24 x 0.5-inch pan-
head Phillips screw
(4 each slide)
shoulder screw on
system
system release
latch
9
10
11
1-24 Rack Installation Guide
All manuals and user guides at all-guides.com
Holding the left slide assembly into position in the rack at the location you marked,
adjust the extended rear bracket tightly against the back of the vertical two-post rack
and secure it to the rail with two 12-24 x 0.5-inch Phillips screws (see Figure 1-18).
I n s t a l l i n g t h e S l i d e A s s e m b l i e s f o r F l u s h - M o u n t
Secure the front bracket on the slide assembly to the two-post rail with two
12-24 x 0.5-inch pan-head Phillips screws (see Figure 1-18).
Repeat step 8 and step 9 to install the right slide assembly in the rack.
Use an 11/32-inch wrench or nut driver to fully tighten the nuts on the mounting
brackets on both slide assemblies that you tightened with your fingers.
joined bracket
slide assembly
slide release latch