Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5X860eb0.fm Page 7 Monday, October 21, 2002 11:49 AM
Place a mark 44 mm (1.75 inches) above the original mark you made (or count up
2
three holes in a rack that meets EIA-310 standards) and mark the rack's front vertical
rails with a felt-tipped marker or masking tape (if you counted holes, place a mark just
above the top hole).
This mark or piece of tape indicates where the system's upper edge will be located on
the vertical rails (see Figure 1-4).
F i g u r e 1 - 4 .
M a r k i n g t h e V e r t i c a l R a i l s
tape on
vertical rail
Installing the RapidRails Slide Assemblies
At the front of the rack cabinet, position one of the RapidRails slide assemblies so that
1
its mounting-bracket flange fits between the marks or tape you placed on the rack (see
Figure 1-5).
The mounting hook on the slide assembly's front mounting bracket flange should
enter the top hole between the marks you made on the vertical rails.
Push the slide assembly forward until the mounting hook enters its respective square
2
hole on the vertical rail, and then push down on the mounting-bracket flange until the
mounting hooks seat in the square holes and the push button pops out and clicks.
All manuals and user guides at all-guides.com
Rack Installation Guide
1-7
Publicité
Table des Matières
