Dell PowerEdge 1750 Guide D'installation page 18

5X860eb0.fm Page 12 Monday, October 21, 2002 11:49 AM
To install the cable-management arm on the back of the system, perform the following
steps:
1
2
3
F i g u r e 1 - 8 .
latch on end of slide assembly
latch on inner segment
of slide assembly
1-12 Rack Installation Guide
All manuals and user guides at all-guides.com
Facing the back of the rack cabinet, locate the latch on the end of the right slide
assembly that you secured to the back vertical rail.
Push the tab on the back end of the cable-management arm into the latch on the end
of the slide assembly (see Figure 1-8).
The latch clicks when locked.
Push the tab on the front end of the cable-management arm into a mating latch on
the inner segment of the slide assembly (see Figure 1-8).
The latch clicks when locked.
I n s t a l l i n g t h e C a b l e - M a n a g e m e n t A r m
tab on front end
tab on back end
cable-management arm
stop block