Re-Fuelling; Gearbox Oil Replacement; Tyre Pressure - Bertolini 316 Utilisation Et Entretien

Fig.13
LUBRICATION (Fig. 13)
TYPE OF LUBRICANT
Engine: see engine manual.
Motorcultivator: use only ESSO UNIFARM
15-40 W oil and ESSO MULTIPURPOSE
grease.
1) ENGINE
Every day: check level and top up if ne-
cessary.
Oil replacement: to be carried out accor-
ding to intervals and methods set out by the
engine manufacturer.
2) GEARBOX (capacity 2,5 Kg)
Every 20 hours: check level and top up if
necessary.
Every 500 hours: replace oil.
3) POWER TAKE-OFF FOR IMPLEMEN-
TS
Before attaching Implements, fill up with
Multipurpose grease.
4) ROTARY HOE BOX
Capacity 0,7Kg.
Every 20 hours: check level and, if neces-
sary, top up through the clearance hole close
to screw A.
Make sure to reassemble the screw together
with aluminium washer B in order to guaran-
tee tightness.
Every 500 hours: replace oil.
GEAR BOX OIL REPLACEMENT
Oil must be replaced when hot, by unscrewing
fill cap A and fill cap B equipped with an oil
dipstick. When oil is completely drained,
replace cap A and pour the new oil through
hole B (2,5 Kg). Check level by using dipstick
on cap B. This operation is to be done with
motor cultivator in horizontal position.
Fig.14

TYRE PRESSURE

Often check that tyre pressure be within the
limits of 1-1,2 bar (Kg/cm
50
(Fig. 14)
).
2