Tripp-Lite SMARTINT2200VS Manuel Du Propriétaire page 6

Basic Operation
Indicator Lights (Front Panel)
All Indicator Light descriptions apply when the UPS is plugged into a wall outlet and turned
ON.
18-08-322-932245.indb 6
"MUTE/TEST" Button
• To Silence (or "Mute") UPS Alarms: briefly press and release the
MUTE/TEST button.
• To Run a Self-Test: with your UPS plugged in and turned ON,
press and hold the MUTE/TEST button for two seconds.* Continue
holding the button until the alarm beeps several times and the
UPS performs a self test. See "Results of a Self-Test" below.
Note: you can leave connected equipment on during a self-test. Your
UPS, however, will not perform a self-test if the UPS is not turned on
(see "ON/OFF/STANDBY" Button description).
CAUTION! Do not unplug your UPS to test its batteries. This
will remove safe electrical grounding and may introduce a
damaging surge into your network connections.
Results of a Self-Test: the test will last approximately 10 seconds
as the UPS switches to battery to test its load capacity and battery
charge.
• If the "OUTPUT LOAD LEVEL" LED remains lit red and the
alarm continues to sound after the test, the UPS's outlets are
overloaded. To clear the overload, unplug some of your equipment
and run the self-test repeatedly until the "OUTPUT LOAD LEVEL"
LED is no longer lit red and the alarm is no longer sounding.
CAUTION! Any overload that is not corrected by the user
immediately following a self-test may cause the UPS to shut
down and cease supplying output power in the event of a
blackout or brownout.
• If the "BATTERY WARNING" LED remains lit and the alarm
continues to sound after the test, the UPS batteries need to be
recharged or replaced. Allow the UPS to recharge continuously for
12 hours, and repeat the self-test. If the LED remains lit, contact
Tripp Lite for service. If your UPS requires battery replacement,
visit www.tripplite.com to locate the specific Tripp Lite replacement
battery for your UPS.
* The alarm will beep once briefly after the indicated interval has passed.
"POWER" LED: this green LED lights continuously when the UPS
is ON and supplying connected equipment with AC power from
a utility source. The LED flashes and an alarm sounds (4 short
beeps followed by a pause) to indicate the UPS is operating from
its internal batteries during a blackout or severe brownout. If the
blackout or severe brownout is prolonged, you should save files and
shut down your equipment since internal battery power will eventually
be depleted. See "BATTERY CHARGE" LED description.
6
5/3/2019 1:44:54 PM