NewAge Products 66992 Guide D'installation Et D'utilisation page 18

Installing Grill on custom built cabinet
Layout for Non-combustible enclosure
Configuration Example 2: With open cutout bottom
Note:
Avoid abrasion of hose against the
opening. It is recommended to use a rubber
grommet at the opening.
Rubber grommet
2.375" Dia
MINIMUM 20 SQ IN (130 SQ
CM) OF VENTILATION
REQUIRED ON EACH END OF
CABINET.
5"
127mm
MAXIMUM
MINIMUM 10 SQ IN (65 SQ CM)
OF VENTILATION REQUIRED ON
EACH END OF CABINET.
MINIMUM 20 SQ IN (130 SQ
CM) OF VENTILATION
REQUIRED.
MINIMUM 10 SQ IN (65 SQ CM)
OF VENTILATION REQUIRED
NOTE: These illustrations are for reference
purpose only. Actual built-in cabinets and
installation may differ.
18
10in
1in
Back View
H
1"
25.4mm
MAXIMUM
Note: The cabinet should not be designed in a
way that a spare cylinder can be stored inside the
enclosure.
The opening of propane enclosure is limited to the
dimensions below:
Width (W1) must be less than 23.5".
Height (H1) must be less than 18.5".
10in
Propane tank must be secured to the built-in cabinet
inside the cylinder enclosure.
D
W
H1
PARTITION TO ISOLATE
CYLINDER FROM GRILL