Gorenje DK 63 MCLI Manuel D'utilisation page 29

eLeCtriCAL ConneCtion
The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug
connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after installation.
If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply
a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions
relating to over-current category III, in accordance with installation instructions.
Warning! Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that
the mains cable is correctly assembled.
The hood is provided with a special power cable ; if the cable is damaged, request a new one from Technical Service.
moUnting
Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must
verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take
the weight of the hood. Do not tile, grout or silicone this appliance to the wall. Surface mounting only.
operAtion
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately
after terminating cooking.
1
1. on / oFF motor / Speed increase
Turning the knob into position "0" during functioning, the hood turns OFF.
Turning the knob from position "0" into position "1" hood passes from the OFF state to speed 1.
Turning the knob in right direction (hood in ON state) the motor speed is increased from speed 1 to intensiva
Speed 1: 1
Speed 2: 2
Speed 3: 3
Speed 4: 4
2. on/oFF lights
mAintenAnCe
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at
the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.
2
29