Preparation Using Ground Coffee; Preparing Milk Froth And Warm Milk - Bosch Vero Professional TCA71-RW Mode D'emploi

en de
Preparation using
ground coffee
This fully automatic espresso machine can
also be operated with ground coffee (not
instant coffee powder).
Drink preparation without milk
À Á
Select or by turning the knob 6.
Place the pre-warmed cup(s) under the
coffee outlet 9.
Open the drawer 18 by pressing.
Pour in no more than 2 level measuring
spoons 14 of ground coffee.
Warning: Do not use whole beans or
instant coffee.
Close the drawer 18.
Press the start button 8.
The coffee is brewed and then dispensed
into the cup(s).
N.B.: Repeat the procedure for another cup
of coffee. If no coffee is taken within 90
seconds, the brewing chamber empties
ance rinses.
Drink preparation with milk
Turn the knob 6 to select Macchiato
Æ
Cappuccino .
Place the pipe 10d of the milk frother 10
in the milk container.
Swivel the coffee outlet 9 to the right until
it clicks into place.
Place the pre-warmed cup or glass under
the coffee outlet 9 and milk frother 10.
Open the drawer 18 by pressing.
Pour in no more than 2 level measuring
spoons 14 of ground coffee.
Warning: Do not use whole beans or
instant coffee.
Close the drawer 18.
Press the start button 8. First milk is
delivered into the cup or glass. After that
the ground coffee is brewed and
dispensed into the cup or glass.
12
Important:
remove, so clean the milk frother 10 with
lukewarm water immediately after use (see
"Cleaning the milk system").
N.B.: Repeat the procedure for another
coffee / milk drink. If no coffee is taken
within 90 seconds, the brewing chamber
The appliance rinses.
Preparing milk froth
and warm milk
Risk of burns
!
The milk frother 10 gets very hot. After use,
The appliance must be ready for use.
Place the pipe 10d of the milk frother 10
in the milk container.
Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
Select the required setting
È
- "Milk froth"
turning the knob 6.
Press the start button 8. Milk froth or
Å
or frother 10 for about 40 or 60 seconds
respectively.
Press the start button 8 again to cut the
process short.
Note:
hear a whistling sound. This is caused by
the milk frother 10 for technical reasons.
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
Important:
remove, so clean the milk frother 10 with
lukewarm water immediately after use (see
"Cleaning the milk system").
É
by