Technical Specifications - cecotec Mambo 9590 Manuel D'instructions

E2 Temperature
sensor error
E3 The motor is
blocked.
E4 The temperature is
too high.
E5 The motor's
temperature is too
high.
E6 The change in
speed could not be
done successfully.
E7 & E8
E12 Scale
measurement
error.

8. TECHNICAL SPECIFICATIONS

Model: Mambo 9590
Product reference: 04150
1700 W (Motor 700 W Heating power 1000 W) 200-240 V~ 50/60 Hz
Made in China | Designed in Spain
The jar is not in its correct
position or connection of the
temperature sensor at the jar
base is damaged.
There is too much food inside
the jar.
There is no or very little
food in the jar and the set
temperature is too high for
too much time.
The robot has been operating
with too much food for a lot
of time.
Speed change between low
level (1-5) and high level (6-
10) was blocked.
The maximum measurement
value has been exceeded.
ENGLISH
Re-assemble the jar and make
sure it is fixed properly.
Remove some food from
inside the jar or cut the food to
smaller pieces and restart the
machine.
Add food in the jar.
Stop operating the machine
and allow it to cool down
before restarting it again.
Remove the jar, turn the fixing
bracket manually and place
the jar again in place. Restart
the robot.
Please, contact the Technical
Support Service of Cecotec at
+96 321 07 28.
Remove weight from the scale
until it reaches a value below
4.999 g.
57