Start-Up; Stop - VITO PRO-POWER VIML150HQA Mode D'emploi

▪ To prevent accidental discharge of high-pressure
water, the gun trigger safety lock should be engaged
whenever the pressure washer is not in use;
▪ When you the machine is under pressure and the
trigger is engaged, a recoil movement is produced
due to the force of the water jet. Adopt a stable and
firm posture. Hold the gun firmly with both hands in
order to prevent accidents.
▪ Do not use the equipment with other people nearby
without protective equipment;
▪ Never point the water jet towards people, animals,
other appliances and electrical systems;
▪ Do not put you hand, fingers or body in front of the
adjustable nozzle. The jet may hurt you.
▪ Keep the pressure hoses connected to the washer
and gun while the system is under pressure. Make
sure the appliance is turned off and without any
pressure before connecting the hoses;
▪ Do not make any modifications to the appliances,
couplings, hoses or other connections;
▪ Do not use the pressure washer to pump fuel or other
flammable liquids;
▪ Always wear safety goggles and individual protective
equipment such as dust mask, hearing protection,
closed-toe shoes;
▪ This device is prepared to work with clean water and
operating temperature between +5°C and +50°C. The
working pressure of the inlet water must be less than
4 bar.
▪ Use the pressure hoses, couplings and fittings
according to technical data and manufacturer's
recommendations. These accessories are important
to guarantee safety;
▪ Do not use excessive pressure. Make sure every
accessory bears the maximum limit;
▪ Vehicle tyres or tyre valves are susceptible to damage
from the high-pressure jet and may burst.
▪ It is not allowed to clean surfaces containing
asbestos;
▪ Cleaning areas should have the necessary inclination
and drainage to reduce the possibility of a fall.
32
▪ Prior to starting the pressure washer in cold weather,
be sure ice has not formed in any part of the
equipment.

Start-up

The device is equipped with an automatic
START/STOP system, based on water pressure.
The motor on this pressure washer does not run
continuously. The motor only runs when the gun's
trigger is pulled. Each time it is released, the washer
stops automatically.
1. Check if the appliance is in a vertical position;
2. Open the water supply tap;
3. Set the trigger gun safety lock (19) to the right to
allow the trigger to be pulled;
4. Press the gun trigger (20) until all the air has escaped
from the pump and water hose;
5. Plug in the power cord (3);
6. Set the "ON/OFF" switch (5) into "ON" position;
7. Press the gun trigger to start working;
8. If you need to change the water outlet mode, turn the
nozzle to the left/right (17);
9. Adjust the distance between the nozzle and the
cleaning surface;

Stop

1. Set the "ON/OFF" switch (5) into" OFF" position;
2. Unplug the power cord (3);
3. Close the water supply tap;
4. Press the spray gun trigger (20) to release the water
pressure;
5. Set the trigger safety lock (19) to the left to lock the
trigger;
6. Wind up the high-pressure hose (6) in the reel, using
the hose reel handle (7);
7. Wind the supply hose;
8. Wind up the power cord and place it in the holder;
Never close the water supply tap before turning off
the washer.