Diono Cambria 2XT Manuel D'instructions page 19

3. While pushing booster against
vehicle seat, pull one adjuster
strap tight and then the other.
Make sure that both
connectors are securely attached
to the vehicle's lower anchors.
4. Booster seat should rest firmly
on vehicle seat bottom and
touching the vehicle seat back. A
gap is acceptable as long as the
head support is touching the
vehicle seat back or headrest. The
entire seat bottom should sit flat
on the vehicle seat.
IMPORTANT:
vehicle seat back. It may also be necessary to adjust the
recline angle of the booster seat to match that of the
vehicle seat.
NOTE: Even with LATCH/UAS connectors properly
attached and adjusted, the booster seat will still have
movement against the vehicle seat back and bottom.
IMPORTANT: DO NOT
interferes with vehicle seat belt.
IMPORTANT:
position, make sure it is does not rock from side-to-side,
otherwise choose a different seating position.
LATCH/UAS
Try to position backrest in full contact with
use LATCH/UAS if installation
When using booster seat in center seating
diono.com | diono.ca
INSTALLATION
3
4
19