Maintenance; Oven Light - GE JCGBS66SEKSS Manuel Du Propriétaire

Maintenance

Oven Light

S HOCK OR BURN HAZARD: Before replacing oven light bulb, disconnect the electrical power to the
WARNING
oven at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
B URN HAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with
CAUTION
bare hands or a damp cloth can cause burns.
Before replacing your oven light bulb, disconnect the electrical power to the range at the main fuse
CAUTION
or circuit breaker panel. Be sure to let the light cover and bulb cool completely.
The oven light bulb is covered with a removable glass cover that is held in place with a bail-shaped
wire. Remove the oven door, if desired, to reach the cover easily. See the Lift-Off Oven Door
section for detailed oven door removal instructions.
Replacing the Light Bulb:
1. Disconnect electrical power to the range.
2. Hold the glass cover stable, so it doesn't fall when
released.
3. Slide near the indent of the cover holder until the
cover is released. Do not remove any screws to
release the glass cover.
4. Replace bulb with a 40-watt household appliance
bulb. Do not touch hot bulb with hand or wet
cloth. Only remove bulb when it is cool.
5. Hold glass cover stable over new bulb.
6. Pull the wire cover holder near the indent until the
indent in the wire cover holder is located in the indent
of the glass cover.
7. Connect electrical power to range.
26
Glass cover
Indent
Wire cover holder
29-6099