Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting

Problem
The appliance
When epilating
does not operate.
When epilating
or shaving
When caring for
feet
The usage time
gets short.
Cannot remove
hair.
The hair becomes
When epilating
stubble.
The appliance
stops during
operation.
The appliance is not
removing the hair
as well as before.
Possible cause
It is not charged.
The switch is turned ON with the adaptor
connected to the household outlet.
The skin protector or discs are deformed,
cracked, or damaged.
Hair dust has accumulated.
Shower gel has adhered to the discs and blade.
The frame is not securely attached.
The appliance is not used at recommended
use temperature.
The appliance is pressed against skin too hard.
Not charged fully
The appliance is used on long hair.
The way the unit is applied or moved is not
correct.
The appliance is pressed against skin too hard.
Not charged fully
Hair dust has accumulated.
The skin protector or discs are deformed,
cracked, or damaged.
Action
Fully charge the appliance.
Charging is only possible when
connected to the household outlet.
Disconnect from the household outlet
before use.
Request repair at an authorized
service centre.
Clean the hair dust.
Wash it off by soaking in warm water.
Reattach it.
Use at the recommended ambient
temperature of 5 - 35 °C.
Contact to skin with gentle force.
Fully charge the appliance.
Use on hair approximately 2 to 3 mm
long.
Refer to page 16.
Contact to skin with gentle force.
Fully charge the appliance.
Clean the hair dust.
Request repair at an authorized
service centre.
21

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Es-ed22

Table des Matières