Vacuum Package In A Canister; Storage - CASO DESIGN VC 250 Mode D'emploi

Please note
► Do not overstuff the bag; leave enough empty length in the open end of the bag (at least a
few inches) so that the bag can be properly placed in the vacuum chamber.
► Do not wet the open end of the bag. Wet bags may not seal properly.
► Clean and straighten the open end of the bag before sealing. Foreign matter or creases on
the bag may result in a faulty seal.
► Press the bag to expel excess air before vacuuming it. Too much air inside the bag may
result in a poor vacuum.
► If the food you're sealing has sharp edges (such as bones or shells) pack the edges with
kitchen paper to avoid tearing the bag
► When vacuum sealing liquid-based foods (such as soups or stew) freeze them first in a
baking pan or tempered dish before bagging and vacuum sealing them.
► Blanch vegetables by cooking them briefly in boiling water. Allow them to cool then vacuum
seal them in convenient portions.
► When vacuum sealing unfrozen food, allow at least two additional inches of bag length for
expansion while freezing. Place unfrozen meat or fish on a paper towel and vacuum seal
with the paper towel in the bag to absorb any extra moisture.
► Before storing foods such as tortillas, crepes or bread, use wax or parchment paper
between them to stack the pieces. This will make it easier to remove an individual piece,
reseal the rest and immediately replace them in the freezer.

5.5 Vacuum package in a Canister

Wipe canister cover and canister and
ensure they are clean and dry.
Fill the vacuum goods into the container.
Be careful not to fill in too much vacuum
goods.
Remove the drip tray from the vacuum
chamber. Connect one end of vacuum hose
at the air intake at device and other end at
connector at canister cover or with adapter at the canister cover.
Press button for canisters (6).
To ensure there is no air leaking between the cover and the canister, use
your hand to push down the cover at the beginning of the vacuum
operation. The device will stop automatically when enough vacuum
pressure is achieved. Remove the vacuum hose from the cover of
container first then from the air intake at device. Replace drip tray into vacuum chamber. You
can cancel the operation at any time by pressing button for canisters (6) again.

5.6 Storage

Store the device in its upright position, out of the reach of children.
13