Safety Equipment And Options - Invacare Action 1 NG Manuel D'utilisation

- Dual handrim DHR (photos 27 & 28):
This new quick release system allows the user to drive the
wheelchair with a single arm using two handrims on the same
wheel with 2 possible side positions of the small handrim
(right or left available).
1. The removable and interchangeable rear wheels facilitate
transport as well as change of the control side.To dismantle
the wheel, push the button (A) and remove the wheel from its
support.
To prevent falls and injuries, it is essential that the
button (A) is fully engaged providing perfect locking of the
EN28
rear wheels. (See paragraph 2.3.3)
2. Two positions of the small handrim are possible to facilitate
the propulsion:
1) internal position
C
27
A
B
28
2) external position
Unscrew the three fixation bolts (B), position the small
handrim depending on the needed configuration, firmly
tighten the three bolts.
To fold the wheelchair, take the transmission shaft (C) off by
sliding one part inside the other.
To facilitate this operation move the small handrim forwards
to backwards.You can now roll the folded wheelchair.
Please note that the transmission shaft is an integral
part of the wheelchair and the user will be unable to propel
the wheelchair without it.

2.6.3 Safety equipment and options

- Safety standard equipment :
Posture belt (photo 29) : to close the buckle belt, engage part
(A) into part (B), to open press (C).
The posture belt is mounted on the backrest brackets.
C
B
E
D
G
F
A
29