Battery Charger; Battery Charging Procedure - LawnMaster CLGT1018B01 Guide D'utilisation

BATTERY CHARGER

BECOME FAMILIAR WITH THE CHARGER
Before attempting to use this charger, become familiar with all of its operating features and
safety requirements.
1. Power cord with plug
2. Charger
CHARGING THE BATTERY PACK (See Figure 7.)
W A R N I N G
replaced. Failure to heed this warning could result in possible serious injury.
Check the voltage! The voltage must comply with the information on the rating label!

BATTERY CHARGING PROCEDURE:

1. Align the battery pack (2) to the slots on the
charger (1) and slide it in until it locks in place
2. Connect the charger (1) to the power supply.
3. Allow sufficient charging time (3-5 hours), and then
disconnect the charger from the power supply.
4. Press the release button on the battery pack and
remove battery from charger.
NOTE: It is normal for the battery pack and charger
to become warm (but not hot) during charging process.
If the battery does not charge properly, check to make
sure the electrical outlet is "live".
NOTE: Always charge the battery before storage!
To reduce risk of fire, never leave the battery
connected with the charger for more than 24 hours!
(See Figure 6.)
1
12
2
Fig. 6
1
2
Fig. 7