Bialetti Mokissima CF44 Instructions D'emploi page 23

SPONSIBLE FOR ANY DAMAGE DERIVING FROM IMPROPER,
INCORRECT OR UNREASONABLE USES.
• The appliance was designed for internal use and not for extreme temperatures; do not leave it
exposed to the elements (rain, sun, etc.).
• In case of commercial use, use not in compliance with instructions, any damage arising from
an use for other purposes, malfunctioning, non-professional repairing or failure to comply with
instructions, the manufacturer declines any liability and is authorized not to apply the warranty
terms.
• After removing the packaging, and before using the appliance, make sure the appliance and
all the accessories are working well. The power cable and its plug should not be cracked or
in any way damaged or broken. If the conditions described above occur, immediately unplug
the appliance from mains outlet and take it to an authorized After-Sales Service Centre for
necessary checking.
• The packing materials (plastic bags, expanded polystyrene, nails, etc.) should be kept away
from children since they are potential sources of danger.
• Put the appliance on a fl at, smooth and stable surface. Do not put it close to/on hot surfaces
as heaters, cooking hobs, fl ames and similar.
• Before connecting the appliance, make sure the label data correspond to the mains. The label
is located on the bottom of the appliance body.
• If the plug does not fi t into the wall outlet, have the wall outlet replaced with another suitable one
by a qualifi ed electrician. He must also check that the cord is suitable for the power absorbed by
the appliance. In general, it is not advisable to use an adaptor, multiple sockets, or an extension
cord. If they are necessary, use only simple or multiple adaptors and extension cords that conform
to safety regulations, being careful not to exceed the load limits indicated on the adaptor and
the extension cord, and the maximum power indicated on the multiple adaptor.
• If the appliance is not intended to be used for a quite long period, unplug it.
• If the appliance is not intended to be used for a quite long period, empty the water tank.
IT IS RECOMMENDED TO POWER THE APPLIANCE THROUGH A RESIDUAL CURRENT DEVICE
(RCD) WITH A MAX. OPERATING CURRENT OF 30 MA.
CONNECT THE APPLIANCE TO THE POWER MAINS THROUGH AN EARTHED SOCKET. AVOID
UNPLUGGING THE APPLIANCE BY PULLING THE POWER CORD.
WHILE IN USE, THE POWER SOCKET MUST BE EASILY REACHABLE IN CASE IT IS NECESSARY
TO UNPLUG THE APPLIANCE.
NO !!
UK
21