Warnings For The Installation; Payment System Connection; Warnings For The Demolition Of The Machine - FAS International FASTER ICE Mode D'emploi

12

To power up the machine proceed as follows: connect the power cable to the electric power outlet. If the
message "MEMORY CLEARED" appears on the display press the button located on the main board
inside the coin mechanism box to initialise the memory. The message "DOOR OPEN" appears on the
display. The vending machine will automatically begin an autotest. If no errors are identified, the machine
E
will be ready for use.
N

Program the machine (see Chap. "PROGRAMMING"), set the REFRIGERATION PARAMETERS (see
G
relevant paragraph) in accordance with the food products loaded into the automatic vending machine and
L
set the prices.
I

If the machine is supplied with change-giving mechanism, insert the corresponding coins in the change-
S
giving tubes.
H

Load the machine with products (see paragraph Loading the products).
6.4

WARNINGS FOR THE INSTALLATION

The machine is sold without payment system. Therefore whatever default to the machine or damages to
person or things due to an incorrect installation, use or similar caused by the payment system will be only and
exlusively charged to those who have carried out the installation of the machine.
6.5

PAYMENT SYSTEM CONNECTION

The coin mechanism must be connected and disconnected with
the machine switched off.
The connectors required to connect the coin mechanism are located
next to the main board. The vending machine is set up for payment
systems with EXECUTIVE, MDB and BDV protocols.

Fasten the coin mechanism on the support between the two
pins.

Connect the coin mechanism connectors to the machine.

Adjust the coin chute on the coin mechanism opening

Adjust the coin return button leverage
If the machine is disassembled in order to be definitively demolished, it is obligatory to follow the rules in force
regarding the protection of the environment.
All ferrous, plastic or similar materials should be taken to the authorized depots.
Particular care should be given to:
Should you have any queries, you are recommended to contact competent local refuse disposal authorities.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
7

WARNINGS FOR THE DEMOLITION OF THE MACHINE

Whichever type of gases (see identification plate) present in the refrigeration unit should
be recovered with suitable equpment by specialized firms.
Insulation materials should be recovered by specialized firms.
Disposal in compliance with EU 2002/96/EC standards, according to the implementation
of the Directive into the national law.
This equipment complies with Directive 2002/95/EC (RoHS).
MASTER / SLAVE CONNECTION
It is possible to connect a SLAVE machine to the MASTER
machine. Using a serial cable and the connector installed on
the back of the machine.
It is also be possible to connect a Stand-Alone in Slave
mode, see command 58.
FASTER ICE – Issue 00